Kmc-controls XEC-3004 Manuel d'utilisateur télécharger pdf

XEC-3001/3002/3004 1 Installation Guide

Installation Guide

E/I–P Transducer

XEC-3001/3002/3004

(Snap Track) Mounting

The transducers may be mounted in any position.

1. Carefully remove the circuit board from the Snap

Track.

2. Mount the track in the desired location.

3. Replace board in the track. Do not slide or ex the

circuit board while replacing.

Wiring

1. Connect the power.

a. 24 VAC (+20%/–15%, Class 2 Only, 1 VA):

  • Transformer phase lead to “~” (phase).

  • Neutral lead to “GND” (common).

b. 24 VDC (+66%/–8%, 50 mA):

  • Positive to “~” (phase).

  • Negative to “GND.”

NOTE: Any other device connected to this

(Class 2 only) transformer must use the

same common. If you are not sure of the

other device’s polarity, use a separate

transformer. If the shared device is a coil,

use a spike-snubbing device across the coil

to prevent possible malfunctions.

2. Position Input Program Jumper to 1–5 VDC, 2–10

VDC, or 4–20 mA.

3. Connect the input signal wiring, positive to “IN”

and negative to “GND.”

4. Connect the output feedback signal (if required)

positive to “OUT 1–5” and negative to “GND.”

Connections

A clean, dry, oil-free main air supply is required for

proper operation. An internal, non-replaceable lter

is used. If air supply contamination is suspected, use

an external HFO-0006 in-line lter.

The gauge port will accept a 1/8" male NPT pressure

gauge. This allows direct reading of the pressure

output. This port must be plugged if a pressure

gauge is not required.

1. Connect the 20 psi main air to the “M” port.

2. Connect the “B” port to the controlled device

(damper or valve actuator).

(Snap Track) Mounting 1

Connections 1

Wiring 1

Adjustments 2

Manual Override (XEC-3004 Only) 2

Span and Zero 2

Maintenance 2

Models 2

Accessories 2

1 2

Résumé du contenu

Page 1 - Installation Guide

XEC-3001/3002/3004 1 Installation GuideInstallation GuideE/I–P TransducerXEC-3001/3002/3004 (Snap Track) MountingThe transducers may be mounted in a

Page 2 - Accessories

Modèles reliés XEC-3002 | XEC-3001 |

Commentaires sur ces manuels

Pas de commentaire

Kmc-controls XEC-3004 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Relais Kmc-controls XEC-3004. KMC Controls XEC-3004 User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés XEC-3002 | XEC-3001 |

Commentaires sur ces manuels

Produits connexes et manuels pour Relais Kmc-controls XEC-3004